The FLiR Dev Kit includes a breakout as well as a Lepton® longwave infrared (LWIR) imager. With this kit you will be able to bring FLiR's thermal imaging reliability and power to your Arduino, Raspberry Pi, or any ARM based development tool all in an easy to access breadboard friendly package.The Lepton® LWIR module included in each FLiR Dev Kit acts as a sort of camera and packs a resolution of 80 × 60 pixels into a camera body that is smaller than a dime and captures infrared radiation input in its nominal response wavelength band (from 8 to 14 microns) and outputs a uniform thermal image.
Flir Lepton® module Features:
WIR sensor, wavelength 8 to 14 μm
51-deg HFOV, 63.5-deg diagonal
80 (h) × 60 (v) active pixels
Thermal sensitivity <50 mK
MIPI and SPI video interfaces
Two-wire I2C-like serial-control interface
Fast time to image (< 0.5 sec)
Low operating power, nominally 150 mW (< 160 mW over full temperature range)